Making Hardwood Flooring Splines

1 snap a straight line to mark the first course of.

Making hardwood flooring splines.

Width x 42 in. Length x 1 2 in. Flooring installers do this by tapping a makeshift tongue called a spline or slip tongue into the grooves of the boards in the first course. Measure from one corner of the starting wall out the same width of your flooring then add the recommended expansion gap equal to the thickness of the flooring make a check mark on the measurement.

Thickness x 1 2 in. Natural wood grain finish. Hardwood flooring splines are used to change direction for wood flooring that is nailed down. 3 1 4 3 4 4.

Hardwood floor spline is used for a transition piece in tongue and groove flooring when changing the direction of the hardwood floor. Packaged 10 per pack. Spline dimensions are 42 in. Our sliptongue is produced using either red oak or poplar depending on availability.

Each individual spline is 1 4 in. Butâ now imagine putting a lot of stress on a miterâ joint assembled with a thin long grainâ spline. 36 â sold individually or by the pack. Our hardwood floor spline sliptongue is made from domestic hardwoods.

A successful hardwood floor transition requires one of two different joints in order to change the direction of the planks. Hie spline would likely split along theâ grain and the joint would come apart. Parallel wall lines to the flooring direction is where we need to be square. Width x 1 4 in.

The easiest way to make a hardwood spline is to simply rip a thin strip from a board. 3 4 x 3 1 4 would be.